Gear I use

Most customer purchases are made from these machines. Our resin workhorses.

Large-format resin prints. Taking up work from the S4U farm as we phase those out.

We use two of these to test resins and do one-off production runs.

Combo wash and cure unit that fits large items.

If it fits 256 cubed and is PLA, PETG, PETG-CF/GF, or ASA, it'll get printed on these. Our FDM workhorses.

Used for contract work when size or material demands it.

Easy to print, super clear, resists yellowing.

Resins, filaments, and filament dryers from SUNLU.

It prints well, easy to source, good color selection. Zero complaints.

Filament and printer upgrade supplies.

USA-made 3D printing filament.

Usually the cheapest 4 mil nitrile gloves you can find.

4 gallons of the good stuff.

Grease for maintaining printer Z screws.

Oil for maintaining printer rails and rods.

Cleans old grease and debris from printer Z screws.

Keeps shelves clean, easy to wipe down. Very cheap and easy to rip up and replace.

These tubs work well to contain flying parts as you scrape off the buildplate.

These little squeeze bottles with needles are great to shoot IPA into very small cavaties to flush out stubborn resin.

Used for shipping labels, stickers, instruction sheets, and more.

Carbon filtration for the print farm.

Moves air through the carbon filter.

1 micron media for the first filtration pass.

0.5 micron media for final filtration.

IPA-safe housing for filter media.

Moves IPA through the filter stack.